
CC Series
CRYSTALLINE EFFECT INKS

CRYSTAL COAT
Clear Part 1
Clear Part 2
CC-004
CC-006
CC SERIES SOLVENT DYES
Yellow
Gold
Orange
Pink
Red
Blue
Green
Brown
Black
CC-100
CC-101
CC-102
CC-103
CC-104
CC-105
CC-106
CC-107
CC-108
Crystal Coat Two Part/Heat Set Formula For Glass & Metal.
CC Series Inks are recommended for furniture, partitions, architectural elements and other decorative components. When heat set, this unique two part system creates a striking crystalline effect on the printed areas. Crystal Coat exhibits excellent indoor durability, resists abrasion, and superior chemical resistance.
SUBSTRATES​​
Glass | Metal
​
MIXING
For normal use, mix component 1 and component 2 in equal parts. Changing crystal size: crystal size may be increased or reduced by adjusting ratios. Increasing the amount of component 1 increases crystal size. Ratio of component 1 to component 2 may be as high as
4 to 1. (Also see screen mesh comments below).
​
POT LIFE
Approximately 8 hours after mxing.
​
**SCREEN MESH ADJUSTMENTS
Coarser mesh counts will producer, larger, brighter crystals. Finer mesh counts produce smaller, less reflective crystals.
​​
MODIFIERS
Reducer: CC-001
Retarder: CC-005
Flow Promoter: CC-020
​
SCREEN WASH
Use CC-010
SCREEN MESH
65 to 150+
Polyester Monofilament**
STENCILS
Direct method
emulsions,
capillary films
SQUEEGEE
All types, 60 to 80 durometer

CC Inks Will Not Cure By Air Drying
CC Inks Will Not Cure By Air Drying
​BAKE/CURE
Bake Dry: 350°F for 2 - 4 minutes​​
Equipment: for proper application, an industrial conveyorized dryer with air movement (3,000 to 5,000 cfm) is required to achieve an even crystal pattern.
Note: lnformation contained in Cudner & O’Connor product sheets is based on laboratory and field tests. Because we cannot control actual production conditions, no warranty is expressed or implied. Careful testing is always recommended prior to production. Consult with our Technical Services Department on all application issues.
COVERAGE
Approximately 1200 - 1500 Sq. Ft / Gal.